If your current planting goals involve plants that require good water drainage, I am sure you know how frustrating it is to have a yard that just won’t cooperate. Some plants can handle the excess water that comes about from being in an area that doesn’t drain properly. In fact, it might just cause them to bloom more lushly. However, other plants don’t cope as well, and it will cause them to die a gruesome, bloated death. You should always find out about the drainage required for every plant you buy, and make sure that it won’t conflict with any of the areas you are considering planting it in.

In order to test how much water your designated patch of soil will retain, dig a hole approximately ten inches deep. Fill it with water, and come back in a day when all the water had disappeared. Fill it back up again. If the 2nd hole full of water isn’t gone in 10 hours, your soil has a low saturation point. This means that when water soaks into it, it will stick around for a long time before dissipating. This is unacceptable for almost any plant, and you are going to have to do something to remedy it if you want your plants to survive.

The easiest method for improving drainage in your garden is to create a raised bed. This involves creating a border for a small bed, and adding enough soil and compost to it to raise it above the rest of the yard by at least 5 inches. You’ll be amazed at how much your water drainage will be improved by this small modification. If you’re planning to build a raised bed, your prospective area is either on grass or on dirt. For each of these situations, you should build it slightly differently.

If you want to start a raised garden in a non grassy area, you won’t have much trouble. Just find some sort of border to retain the dirt you will be adding. I’ve found that there is nothing that works quite as well as landscape timbers or decking lumber. After you’ve created the wall, you must put in the proper amount soil and steer manure. Depending on how long you plan to wait before planting, you will want to adjust the ratio to allow for any deteriorating that may occur.

If you’re trying to install a raised bed where sod already exists, you will have a slightly more difficult time. You will need to cut the sod around the perimeter of the garden, and flip it over. This may sound simple, but you will need something with a very sharp edge to slice the edges of the sod and get under it. Once you have turned it all upside down, it is best to add a layer of straw to discourage the grass from growing back up. After the layer of straw, simply add all the soil and steer manure that a normal garden would need.

Planting your plants in your new area shouldn’t pose much difficulty. It is essentially the same process as your usual planting session. Just be sure that the roots don’t extent too far into the original ground level. The whole point of creating the raised bed is to keep the roots out of the soil which saturates easily. Having long roots that extend that far completely destroys the point.

Once you have plants in your new bed, you’ll notice an almost immediate improvement. The added soil facilitates better root development. At the same time, evaporation is prevented and decomposition is discouraged. All of these things added together makes for an ideal environment for almost any plant to grow in. So don’t be intimidated by the thought of adjusting the very topography of your yard. It is a simple process and the long term results are worth every bit of work.

If you’re looking for ways to keep your garden watered without wasting too much time and money, you’ve probably gone through a lot of options in your mind. Maybe you’ve considered a sprinkler, a hose, or a good old-fashioned watering can. All of these methods might be convenient, but most of the time you will end up wasting water on plants that don’t need any more. If you live in a drought stricken area like I do, you know that every bit of water counts. I ended up getting a drip irrigation system. I haven’t regretted this decision at all.

When you install a drip irrigation system, you can choose one of two varieties: above ground and below ground. The above ground version drips small amounts of water continuously onto the ground, and allows it to soak in. It is all regulated from a pressure controller, which ensures that the water just comes out at a drip instead of a spray or a stream. These pressure regulators are very inexpensive. The whole drip system can be set up with a pressure regulator and a garden hose with holes poked in it (although it is best if you to get a pipe designed for this type of use, I’ve found that the hose method works acceptably).

The underground system is a bit more of a pain to install and maintain. But if you’re really into the aesthetic aspect of your garden and don’t want any visible watering system, then you might consider it worth it. It’s essentially the same as the above ground version, only a small trench is dug for the hose or pipe prior to any planting. This allows the water direct access to the roots for the most watering efficiency. Plus, you can impress your neighbors by having a beautiful garden without ever going outside to water it! They’ll be baffled.

To choose between the two systems, you need to take several things into account. Do you have the same plant layout year round? If it is always changing, you probably won’t want to bury your hose. It can be a pain to dig it up and re-align it with all your new plants every year or so. Even if your plant layout never changes, you need to consider how much you really mind seeing a hose in your garden. If it really bothers you to the extent that you’re willing to work for a few hours to get rid of it, then by all means bury it. But otherwise I would suggest staying above ground, if for nothing else than the convenience of repairing and rearranging.

One of the main advantages of the drip irrigation system is its efficiency. Instead of spraying large amounts of water willy-nilly like a hose does, it makes the most of your precious water by putting it exactly where it is needed. It can also provide your garden with constant watering, instead of just having to go thirsty whenever you’re not around to water it.

So if you’re looking for an easy, cheap, convenient, and efficient alternative watering method, you should go out to the gardening store today and purchase the necessary items to install a drip irrigation system. I think you’ll be surprised at how much easier it is to maintain a garden after you have it.

Many people worry when it comes to caring for their indoor plants. When talking about house plants, there is no need to worry. There are just a few things you need to consider.

1. Watering
Overwatering kills most houseplants. Looks can be deceptive, so to see if your soil is dry enough to water, try the finger test. Insert your index finger up to the first joint into the soil. If the soil is damp, don’t water it.

2. Feeding
Foliage plants usually have high nitrogen needs, while flowering plants, K2O is needed. Slow release fertilizers can be mixed with the compost. However, certain plants like cacti and orchids need special fertilizer. Feed plants during their most active growth period.

3. Lighting
Plants like Sanseveria and Aspidistra require no sun. They can be placed away from a window. Spider plants need semi-shade. You can put plants like these near a window that does or does not get sunlight. Generally speaking the darker the leaves the less light is needed. Check the labels to see what your plants need.

4. Temperature
Houseplants can survive in cool or warm temperatures, but drastic fluctuations of temperature may not be good for them. One thing that most plants cannot survive is gas heating. If you have a plant that likes warm conditions, don’t put it near an air conditioner in the summer.

5. Humidity
Some houseplants require a humid environment. One tip to maximize humidity is to put the pot inside a larger pot and fill in the gaps with stones or mulch to keep in the moisture. Grouping plants together often creates a microclimate that they will benefit from. If you want, you can mist them with water once or twice a day depending on the temperature.

6. Re-potting
Some plants require re-potting for optimum growth but there are others that resent having their roots disturbed. Or their roots system may be small enough that they don’t require re-potting. One way to check if your plant needs re-potting is to turn it upside down. Tap the pot to release the plant and check its roots. If roots are all you see, then re-pot. Sometimes the roots will come out of the pot. You should either cut them off or re-pot the plant.

You just need to have a little care for your plants and in turn, you’ll reap the benefits. Indoor plants not only add to the beauty of your décor, but help clean the air of polutants as well as brighten up the blahs of winter.